The START control panel enables a roller shutter door to be controlled by low voltage key, rocker or push button switches, it also has the facility to connect a safety device, and has an automatic or deadman closing option.

• Power supply 230V ac
• Maximum motor power 0.75 HP single phase
• Safety device connection which is only active when the door is closing, stops and reverses the motor when activated
• Open and Close switch connections
• Adjustable motor run time, 0 - 90 seconds
• Dimensions 172 x 122 x 60 mm, IP53

Note: This control panel does not have a built in radio receiver

Roller shutter control panel with built in 868 MHz receiver for remote control operation, can be controlled by wired push buttons, handheld transmitter, wireless keyswitch and wireless push buttons and has an automatic or deadman closing option*

• Power supply 230V ac
• Maximum motor power 0.75 HP single phase
• 868 MHz receiver, self learning, 15 code memory, built in antenna
• Resistive safety edge connections (8.2K) x 2, this acts on opening and closing stopping the door for 1 second and then reversing**
• Safety device input for connection of photocells, this is only active when the door is closing, stops and reverses the door when activated**
• Open and Close switch connections
• Adjustable motor run time, 1 - 120 seconds
• Remote programming of additional transmitters by radio
• Dimensions 220 x 140 x 55 mm, IP54, IP65 with cable gland

TRANSMITTERS

* Deadman closing by wired push button, wireless keyswitch or wireless push button, but not by handheld transmitter

** Selectable function either safety device or safety edge, but not both

WIRELESS 868 MHz KEYSWITCH

• Power supply 3V lithium battery
• Spring loaded center off, up and down control, marked with up and down arrows
• Supplied with 3 numbered keys
• Dimensions surface mount 75 x 75 x 65 mm, flush mount 75 x 75 x 58mm diameter, metal construction, IP43

WIRELESS 868 MHz PUSH BUTTONS

• Power supply 3V lithium battery, low battery indication
• Up and down push buttons
• Dimensions 84 x 74 x 14 mm, surface mount, IP20

Roller shutter control panel with built in 433 MHz receiver for remote control operation, can be controlled by wired push buttons, handheld transmitter or wieless digital keypad (see transmitters)

• Power supply 230V ac
• Maximum motor power 0.75 HP single phase
• 433 MHz receiver, self learning, 31 transmitter code memory, built in antenna
• Safety device input for connection of photocells, this is only active when the door is closing, stops and reverses the door when activated*
• 24V ac, 0.15A auxillary output
• Start and stop switch connections
• Courtesy light output, volt free contacts
• External limit switch connections
• Autoclose option, adjustable waiting time 6 - 90 seconds
• Adjustable motor run time, 3 - 60 seconds
• Remote programming of additional transmitters by radio
• Dimensions 172 x 122 x 60 mm, IP53

TRANSMITTERS

* An adaptor is available that converts the Safety input into a resistive safety edge (8.2K) input