A roller shutter and roller garage door remote control with wireless safety edge system compatible with optical, resistive and mormally closed contact safety edges. Facilitates compliance with EN 12453, EN 12445 and EN ISO 13849-1
CONTROLLER
- Power supply 230V ac ±10%
- Maximum motor power 555 0W
- Built in 868.35 MHz, narrow band radio receiver, high security rolling code system, 15 transmitter code memory
- Remote control operating range up to 200 metres
- Built in 2nd generation multi frequency wireless safety edge receiver, 868.700 - 870 MHz with 433MHz security channel
- Wireless safety edge operating range 10 metres minimum
- The safety edge is inhibited during the last 4cm of closing
- Independant adjustable open and close motor run times, 1 – 120 seconds, the time is digitaly set using the programming push button
- Autoclose, selectable by DIP switch, wait time 1 – 120 seconds, 45 seconds default, time set with the programming push button
- Open and close safety inputs (N.C) for connection of photocells or magnetic loop detector, on opening activation causes the motor to stop and reverse for 2 seconds, on closing the motor will stops and reverse to the fully open position
- 24V ac auxiliary power output, 100mA max
- Autotest for both open and close safety inputs, on or off selectable by DIP switch, 24V ac output
- Start push button connection
- Dead man close option, selectable by DIP switch, allows for dead man closing by wired push button or keyswitch (separate open and close connections), wireless push button and wireless keyswitch. Dead man close by hand held transmitter is not possible. The open connection can be connected to a fire alarm control panel to open the door in the event of a fire.
- Remote programming of additional transmitters with audible status indications
- Integral antenna
- Operating temperature -20ºC to +85ºC
- Dimensions 220 x 140 x 55 mm
- Protection IP65
- When used with a safety edge this system complies with the European door normative EN 12453 and EN 12445 and EN ISO 13849-1
WIRELESS SAFETY EDGE TRANSMITTER
- Power supply 3V DC (2 x 1.5V LR6 AA batteries), 2 year battery life, audiable transmitter low battery warning at receiver
- Operating range 10 metres minimum
- Can be used with the following safety edges, low power optical (3V / 3mA) ie Fraba and WITT, 8K2 resistive and normally closed
- When used with an optical safety edge power for the optical system is suppled by the safety edge transmitter, the optical safety edge remains in standyby mode untill it receives an activation signal from the receiver, the activation signal is sent during the auto-test and enables the optical safety edge for 60 seconds
- The transmitter and receiver are in fact transceivers and constantly communicating with each other, should any part of the system fail, the controller will prevent the door operating, the system is therefore fail safe
- Operating temperature -20ºC to +85ºC
- Dimensions 151 x 60 x 23 mm
- Protection IP65
REMOTE CONTROL TRANSMITTERS
- Frequency: 868.35 MHz
- 2 channels
- High security rolling code
- Range: Up to 200 metres
- Power: 3V lithium battery type CR2032
- Dimensions: 56 x 33 x 8 mm
- Customise options: Your company name and logo can be printed or laser engraved on the transmitter and a unique company installer code can be added
The ROLLB2 KIT comprises 1 x roller shutter / roller garage door control panel, 1 x safety edge transmitter and 2 x remote control transmitter
|
