The RCS7-868 series of remote controls have been developed to satisfy the demands of the commercial roller shutter and domestic roller garage door market for a low cost, high quality, reliable and easy to install remote control system.

Operating on the new European permitted frequency of 868.35 MHz exclusively for use by remote controls the RCS7-868 is not subject to interference from other radio signals such as wireless headphones, walkie-talkies, wireless alarm systems, TETRA emergency communications system, etc

ROLLER SHUTTER REMOTE CONTROL - RCS7-868

• High security 868 MHz rolling code system with narrowband radio receiver to prevent interference from other radio signals
• 100 meter range
  
• Hold to run (deadman) or push to run closing options
• Deadman closing by transmitter and connected key switch, rocker switch or push buttons
• Courtesy light output, the light can also be switched on without operating the door by pressing the stop transmitter button
• Low voltage open and close switch inputs for connection of a key switch, rocker switch or pushbuttons
• The open switch input can be connected to a fire alarm contact to automatically open the door in case of fire
• Photocell safety input, only operates when door is closing, when activated the door stops and then reverses, works in both push to run and deadman closing mode

Available with with integral open/close switch

ROLLER GARAGE DOOR REMOTE CONTROL WITH INTEGRAL COURTESY LIGHT - RCS7L-868

The RCS7L-868 roller shutter remote control with integral courtesy light has been developed for use with roll up garage doors.

Operational specifications are the same as the RCS7-868 with the following exceptions, there is no external courtesy light output, a step by step manual push button input replaces the seperate open and close push button inputs.

Available with integral push button

TRANSMITTER - T1

Single channel remote control transmitter with seperate open, close and stop buttons. A sliding safety cover prevents accidental activation of buttons, supplied with key ring attatchment.

5 CHANNEL TRANSMITTER - GT1

Five channel transmitter for use with the RCS7-868 roller shutter and RCS7L-868 roller garage door remote control receivers.

Allows up, down and stop control of up to 5 receivers either individually or simultaneously.

The receiver to be controlled is selected using the SEL button, a LED light indicates the receiver selected, the up, down and stop buttons control the selected receiver.
Pressing the SEL ALL button selects all the receivers, all the LED's light and the up, down and stop buttons control all the receivers simultaneously.

Supplied with wall mounting holder